Trinity TRI2116

27 turn 24 degree NORRCA/ROAR legal stock motor Motor shaft has been designed with a special taper on the end that makes it easy to identify Armature and endbell are easy to remove for repair or replacement Armature is epoxied in tag to identify motor manufacturer and the wind on the armature (Epic 27) Wire gauge may be easily measured with calipers to check its legality on armature is removed from the motor setup Large inspection hole allows spot checks of commutator Alignment mark on can and endbell line up to insure endbell has not been altered to change timing Large hold around bushings makes checking for ball bearings possible while motor is still assembled Endbell is held on with 2 screws Overhead springs allows soldering both leads to the same side of the endbell. Brush stabilizing system Preinstalled surface mount capacitors - no need to solder capacitors to the motor A symmetrical can venting increases magnetic timing Matched P2K Wet Pressed magnets New P2K Z-Speed Armature Pure Copper brush hoods and heatsinks for lower resistance and better cooling