Trinity TRI12001
$29.88
in stock? NO
This item is on back-order. It's difficult to know when it will be available to ship.Co27 stock motor
New for 2006 and sure to be at the top of many stock racers wish lists,
this is the Trinity CO27 Monster Stock Motor.
This next generation stock motor is designed for use with todays
high capacity battery packs.
27 turns, 22 awg wire, and 24 degree locked timing
Meets all ROAR/ARCOR specifications
New High Inertia Rotor Technology provides more mid range and broader
power band, lower operating temperatures and new wire to commutator
fusing process for lower resistance
Revised cooling holes in the can not only improves cooling but alters
the can's magnetic field for increased "Virtual Timing".
Improved bushing alignment with reduced surface bushings for less
drag and more rpm
Pure copper endbell hardware for lowest resistance
Improved brush to hood fit and brush hood alignment
Flat can prevents cheaters from advancing the motors timing
Dual bushing supported
Factory installed, surface mounted capacitors
Laydown style brushes
One CO27 Monster Stock Motor
Motor leads and connector of modeler's choosing
length: 2.22" (56.45mm) not including the shaft
Can diameter: 1.42" (36mm)
Shaft diameter: 1/8"
The stock brushes and springs that comes with this motor are not
available from Trinity. When it comes time to replace brushes and
springs order TRIC4397 - E Brush Silver Laydown and TRIC5414 -
Spring Set (use the red spring on the the positive side and purple
spring on the negitive side).
For the Pro version of this motor order stock number TRIC2002
kpm02/15/2006
ir/jxs
this information was sourced from Great Planes Model Distributors
this is the Trinity CO27 Monster Stock Motor.
This next generation stock motor is designed for use with todays
high capacity battery packs.
FEATURES:
27 turns, 22 awg wire, and 24 degree locked timing
Meets all ROAR/ARCOR specifications
New High Inertia Rotor Technology provides more mid range and broader
power band, lower operating temperatures and new wire to commutator
fusing process for lower resistance
Revised cooling holes in the can not only improves cooling but alters
the can's magnetic field for increased "Virtual Timing".
Improved bushing alignment with reduced surface bushings for less
drag and more rpm
Pure copper endbell hardware for lowest resistance
Improved brush to hood fit and brush hood alignment
Flat can prevents cheaters from advancing the motors timing
Dual bushing supported
Factory installed, surface mounted capacitors
Laydown style brushes
INCLUDES:
One CO27 Monster Stock Motor
REQUIREMENTS:
Motor leads and connector of modeler's choosing
SPECIFICATIONS:
length: 2.22" (56.45mm) not including the shaft
Can diameter: 1.42" (36mm)
Shaft diameter: 1/8"
COMMENTS:
The stock brushes and springs that comes with this motor are not
available from Trinity. When it comes time to replace brushes and
springs order TRIC4397 - E Brush Silver Laydown and TRIC5414 -
Spring Set (use the red spring on the the positive side and purple
spring on the negitive side).
For the Pro version of this motor order stock number TRIC2002
kpm02/15/2006
ir/jxs
this information was sourced from Great Planes Model Distributors
WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov