Hull: Molded ABS offshore deep "V" with molded-in strakes and built-
in foam flotation
Motors: Two Titan Marine 550 size, fan cooled with T-6 aluminum
motor plate and composite nylon motor mounts
Speed Control: Electronic, BEC 14.4 volt fully proportional forward
and reverse with water cooled heat sink
Outdrive: Dual, steerable
Waterproof Receiver Box: Twist lock fastener to seal positively
against the rubber gasket
Drive System: Gear drive, 2:1 reduction
Propellers: Counter rotating to prevent torque roll and eliminate the
need for drag-inducing trim tabs
Radio: 27mHz TRA TQ 2-channel pistol grip with steering and
throttle trim, servo reverse and throttle neutral adjust with a
50/50 setting allowing equal throttle travel between forward and
reverse or a 70/30 setting allowing more (70%) throttle and less
(30%) reverse

YOU WILL RECEIVE:

ABS hull, with waterproof radio box, two 550 size motors, electronic
speed control, TQ transmitter, full color die-cut decals, 2 props

REQUIREMENTS:

Batteries: Eight AA batteries for radio transmitter and two 7.2V
6-cell flat battery packs for motor
Charger: For motor batteries
Tools: Phillips and flat blade screwdrivers, hobby knife, needle nose
pliers

SPECIFICATIONS:

Hull Type: ABS plastic
Hull length: 31" (787mm)
Beam (width): 8.25" (209mm)
height: 4.5" (114mm)
Weight: 56oz (1.587kg)
Dead Rise Angle: 24 degrees
Draft: 4.5" (114mm)
Drive System: Gear Drive, 2:1 reduction
Outdrive: Adjustable Surface Piercing
jxs 9/24/03
this information was sourced from Great Planes Model Distributors

WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov