Tekin TEKTT2756

This is the Tekin RSX Sensored/Sensorless Electronic Speed Control, and the Redline GEN3 2.5 Turn Brushless Sensored Motor. RSX ESC, TEKM1158 Operates brushed or brushless, sensored or sensorless motors LiPo safe with custom voltage cutoffs HotWire PC programming port (Hotwire not included & must be purchased separately, TEKM1451) Datalogging capability D2 Dual Drive Mode technology On-board temperature indicator Sensor plug for precise commutation with all motors High speed fan for maximum cooling Programming features include; High voltage 6.0/7.4V BEC (battery eliminator circuit) 13 step drag brake/brake/reverse strength Current limiter (none + 12 steps) Neutral width (13 steps) Timing Profiles (5 preset - 2 custom)* Adjustable throttle and brake minimums Custom throttle curves Motor/Reverse Type: Brushless, Brushed, No Rev, Rev Delay Voltage cutoffs (none, 2S, 3S, Custom) Timing Boost and Turbo when used with Hotwire ROAR Race Spec "Blinky" Mode Save, Load and Share data log and custom ESC setup files* *Requires Hotwire (sold separately) Redline GEN3 2.5 Turn Motor, TEKC2717 CNC machined T 6061 billet aluminum heat sink can For on- or off-road use 12.5mm performance rotor Dual-plug sensor wire harness for all sensored and sensorless systems Anodized end-bell plates maximize corrosion and wear resistance High RPM precision ball bearings Neodymium sintered magnet Rebuildable Adjustable timing Low resistance solder tabs Solderless sensor PCB replacement RSX ESC with Fan, two Zip Ties, Capacitor, 12AWG Motor Wires, On/Off Switch, Receiver Connector and Instructions Redline GEN3 2.5 Turn Brushless Sensored Motor with Sensor Wire ESC; Input Voltage: 4-9 Cells, 2S-3S LiPo BEC: 6.0V/7.4V, 5.5amps Motor Limit Brushless Mode 2S: 2.5 Turn 2-pole, 4lb chassis Motor Limit Brushless Mode 3S: 8.5 Turn 2-pole, 4lb chassis Motor Limit Brushed 2S: 6 Turn, 36mm Can Motor Limit Brushed 3S: 12 Turn, 36mm Can Max Current: 180amps per phase Timing Profiles: 7 choices (on board) Brushed Modes: Fwd Only, Fwd/Rev, Rev Delay Brushless Modes: Fwd Only, Fwd/Rev, Rev Delay 1.22 x 1.46 x .82" (31.2 x 37.2 x 21mm) Weight: 1.5oz (42g) 2.5T Motor; Input Voltage: 2S all, 3S-10.5 and up Shaft 3.2mm (1/8") x 15.3mm Weight: 5.6oz (158g) Motor Diameter: 1.40" (35.85mm) Motor Length: 1.9" (48.5mm) Bearing Front: 4x13x5mm / Rear: 1/8x3/8x5/32" jxs 02/22/16 ir/jxs &