Tekin TEKTT2745

This is the Tekin RS5 Gen 3 Brushless Sensored 13.5T Motor and the RS Gen2 Spec Brushless Electronic Speed Control. TT2707 13.5T Motor (TEKC2707); CNC machined T 6061 billet aluminum heat sink can For on- or off-road use 12.5mm performance rotor Dual-plug sensor wire harness for all sensored and sensorless systems Anodized end-bell plates maximize corrosion and wear resistance High RPM precision ball bearings Neodymium sintered magnet Rebuildable Adjustable timing Low resistance solder tabs Solderless sensor PCB replacement ESC (TEKC1155); Compatible with sensored, sensorless, brushless, and brushed motors Datalogging capability True ROAR spec mode only, no timing or boost features available High voltage programmable Battery Eliminator Circuit (BEC) HotWire PC interface for advanced programming and updating, EZ access programming port (HotWire Interface (TEKM1450), and Gen 2 Adaptor (TEKM3825) required) Forward, brake, and reverse operation D2 Dual Drive Mode technology On-board temperature indicator Sensor plug for precise commutation with all motors Gold plated solder posts Pit tune mode HDAC: High Density Copper PCB's Self test diagnostics and factory reset DGF2 Digital Glitch Filtering V2 QuickTune programming with one-touch radio calibration 120 day limited warranty through Tekin beginning at date of purchase RS Gen 2 Spec D2 Brushless ESC with Instructions, Motor and Receiver Wires Redline GEN3 13.5 Turn Brushless Sensored Motor with Sensor Wire ESC; Input Voltage: 4-7 cells NiMH/NiCd, 2S LiPo BEC: 6.0V / 3.7V Amperage: 60A per phase Motor Limit Brushless Mode 2S: 13.5T 2-Pole 36mm Can Motor Limit Brushed Mode 2S: 20 Turn 36mm Can Max Chassis Weight: 4lbs (1815g) Throttle Profiles: 7 choices on-board Brushed Modes: Fwd Only, Fwd/Rev, Rev Delay Brushless Modes: Fwd Only, Fwd/Rev, Rev Delay 1.0 x 1.3 x .51" (26 x 34 x 12.9mm) Weight: .80oz (22.5g) 13.5T Motor; Input Voltage: 2S all, 3S-10.5 and up Shaft 3.2mm (1/8") x 15.3mm Weight: 5.6oz (158g) Motor Diameter: 1.40" (35.85mm) Motor Length: 1.9" (48.5mm) Bearing Front: 4x13x5mm / Rear: 1/8x3/8x5/32" Rotor Size: 12.5mm jxs 02/22/16 ir/jxs &