Tamiya TAM57872

This is the 1/10 scale, radio controlled, electric powered, ready to run XB Neo Fighter Buggy. For ages 14 and above. Chassis: DT-03 plastic monocoque Drive: Rear wheel Radio System: Tamiya Finespec 2.4GHz pistol grip with steering and throttle trim and reverse and steering servo Electronic Speed Control: Tamiya TEU-105BK with reverse (TAMC5055) Motor: 540 brushed, preinstalled to assembled gearbox Suspension: Four wheel double wishbone Differential: Bevel gear Body; Painted polycarbonate Driver Figure: Painted plastic Shocks: Coil over plastic body friction, not oil-filled Wheels: White plastic star dish design Tires: Front, grooved Rear, pin spike Steering: Direct servo with tie rods Front Bumper: Spring type to absorb minor impacts Camber: Non-adjustable, camber refers to the angle of the tops of the tires from vertical when viewed from front or behind vehicle Steering Tie Rods: Adjustable, caster/toe-in refers to the angle of the front suspension when viewed from the side of the car in relation to the chassis RTR Tamiya Neo Fighter Buggy with brushed motor, ESC, painted body, Rear Wing, 17T pinion gear, tires, wheels, shocks, decal sheet, 2.4GHz Radio and instruction manual Battery: 7.2V stick pack with standard connector Battery Charger: To match selected battery AA batteries: Four for transmitter Track and Maintenance equipment Vehicle- Length: 16" (406mm) Width: 9-5/8" (245mm) at widest point Weight: 2lbs 6oz without electronics or battery Ground Clearance: 1" (25.4mm) w/about 1/2" (12.7mm) adjustability Body- Length: 11.4" (289mm) Width: 3.5" (90mm) Height: 2.5" (64mm) To Upgrade to Ball Bearings use: Qty. Size Location Qty. Bearing Set 2 5x11mm Rear Uprights 1 DTXC1547 4 5x11mm Front Uprights 2 DTXC1547 8 5x11mm Front Uprights 4 DTXC1547 jxs 02/04/14 ir/jxs &