Robart ROB463F
$9.95
in stock? NO
This item is on back-order. It's difficult to know when it will be available to ship.463F Carbide Cutter 1/4 inch Rod Fine
Robart brand Rough 'n Tough Carbide Cutter (Fine Rod) from Robart.
Made of virtually indestructable tungsten carbide bonded on steel
shanks.
Won't wear out, load up, break down, or overheat.
For use in shaping all woods, plastic, fiberglass and ceramics.
Fine grit.
Rod shaped.
One Carbide Cutter (Fine Rod)
Dremel High Speed Rotary Tool
Shank: 1/8
diameter: 1/4
Not recommended for use on metal.
kr1/14/02
ir/kh
WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov
FEATURES:
shanks.
Won't wear out, load up, break down, or overheat.
For use in shaping all woods, plastic, fiberglass and ceramics.
Fine grit.
Rod shaped.
YOU WILL RECEIVE:
One Carbide Cutter (Fine Rod)
REQUIREMENTS:
Dremel High Speed Rotary Tool
SPECIFICATIONS:
Shank: 1/8
diameter: 1/4
COMMENTS:
kr1/14/02
ir/kh
WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov