Robart ROB160WC
$149.95
in stock? NO
This item is on back-order. It's difficult to know when it will be available to ship.Fork Pneumatic Retract Tail Wheel
Robart brand large scale retractable tailwheel with forked axle for the tailwheel
and air cylinder. For use with planes upto 40 lbs.
FEATURES:
This Unit Comes Pre-Assembled with an Air Cylinder and Tailwheel
Axle Attached.
Steerable with a Pull-Pull System Attached to the Rudder Servo.
YOU WILL RECEIVE:
One Retractable Tailwheel w/Air Cylinder and Tailwheel Fork Axle
One Instruction/Parts List Sheet
REQUIREMENTS:
Pressure Tubing to Reach from the Main Control Unit to the Air Ram
One 2 Tailwheel
Plastic Sleeved Pull-Pull Steel Steering Cables(Goes to Rudder Servo)
Four #6-32 Mounting Screws
Four #6-32 Blind Nuts
Four 3/8 x 1/2 Maple Mounting Blocks
Four Dowel Pins (Used to Mount Maple Mounting Blocks to Bulkhead)
Epoxy
SPECIFICATIONS:
Retract Mounting Brace height: 2-11/16 (68.5mm)
Retract Mounting Brace width: 2
Height from Axle Center to Bottom Retract Brace: 2-1/8 approx.
Extended Length from Axle Center to Retract Brace Mount: 3-11/16
Retracted Length from Axle Center to Retract Brace Mount: 4-1/8
COMMENTS
On the Air Cylinder: Extend Fitting is Located Forward and the
Retract Fitting is Located Aft.
For the Offset Axle Version, use ROBQ2225.
JAL 2/2/99
ir/jl
WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov