RC Lights RCL5056
$64.99
in stock? NO
This item is on back-order. It's difficult to know when it will be available to ship.discontinued Nightfly 14 LED Controller
Product Features
*Full-function LED controller with two adjustable strobes, adjustable rotating beacon, constant navigation, landing lights, and complete TX/RX control built right in
*Power directly from the RX or optional power source Overview The central point of every LED lighting system is the LED controller. It is this component that is going to appropriately power the LEDs so they do not get too much power and blow. It also separates the LEDs into independently controllable groups to which specific functionality can be assigned. It is the brain that tells the LEDs how and when to light. Directly power up to 14 LEDs. Current limiting resistors are built right in. Using the NIGHTFLY 14 LED Controller, LEDs can be directly powered from the RX or an additional power source. LEDs are split into five banks: 4 constant; 4 switched on/off depending on TX 2-pos switch position (Landing Lights); 2 fully-adjustable single strobes; 2 fully-adjustable single/double strobes; and 2 simulated rotating beacon lights (adjustable fast/slow). The NIGHTFLY 14 LED Controller has two TX/RX signal inputs; one is for switching auxiliary (landing) lights on/off; the second is for switching power to the entire controller on/off. Each signal input should be plugged into an available RX channel tied to a 2-position switch on the TX. A Y-harness or RX Pass-Thru can be used on channels in use, but still provide the correct signals for switching (i. e. landing gear channel). Link additional controllers using the extra set of PWR & AUX inputs.
*Lights are designed to be used in extreme nighttime and low visibility running environments and are very high output.
*DO NOT look directly into beam.
*Full-function LED controller with two adjustable strobes, adjustable rotating beacon, constant navigation, landing lights, and complete TX/RX control built right in
*Power directly from the RX or optional power source Overview The central point of every LED lighting system is the LED controller. It is this component that is going to appropriately power the LEDs so they do not get too much power and blow. It also separates the LEDs into independently controllable groups to which specific functionality can be assigned. It is the brain that tells the LEDs how and when to light. Directly power up to 14 LEDs. Current limiting resistors are built right in. Using the NIGHTFLY 14 LED Controller, LEDs can be directly powered from the RX or an additional power source. LEDs are split into five banks: 4 constant; 4 switched on/off depending on TX 2-pos switch position (Landing Lights); 2 fully-adjustable single strobes; 2 fully-adjustable single/double strobes; and 2 simulated rotating beacon lights (adjustable fast/slow). The NIGHTFLY 14 LED Controller has two TX/RX signal inputs; one is for switching auxiliary (landing) lights on/off; the second is for switching power to the entire controller on/off. Each signal input should be plugged into an available RX channel tied to a 2-position switch on the TX. A Y-harness or RX Pass-Thru can be used on channels in use, but still provide the correct signals for switching (i. e. landing gear channel). Link additional controllers using the extra set of PWR & AUX inputs.
SPECIFICATIONS:
DIMENSIONS:
1.65" x 1.0" x 0.25" INPUT VOLTAGE: 3.6-7.4V [6V Optimal] TYP OUTPUT CURRENT (per LED channel): 20-30mA Controller pins can be directly soldered to for DIY projects. Use heat shrink to insulate each pin. *Lights are designed to be used in extreme nighttime and low visibility running environments and are very high output.
*DO NOT look directly into beam.
WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov