Ofna OFN53211
$114.88
in stock? NO
This item is on back-order. It's difficult to know when it will be available to ship.Hyper .21 W/Pull Start
This is a .21 Turbo/Hyper with pull start Ofna engine.
This engine is used to power 1/8th scale R/C kits.
*NOTE* Some kits require extra items to install and operate
this engine. Check kit requirements for these parts.
Oversized flow-through Black anodized cylinder head
ABC construction (Aluminum piston with a chromed brass cylinder)
Rear exhaust
Ball Bearing-supported crankshaft
Slide Valve rotatable Carburetor
Needle valve adjusted by a screwdriver
Pilot Shaft
One .21 Ofna Hyper engine w/Slide Valve Carburetor
One Brass collet (these hold flywheel in place)
One Header with seal, clamp and spring
One Running and parts information sheets
One Hyper .21 Decal sheet
Displacement: 3.49cc (.21 cubic inches)
Bore: 16.26mm Stroke: 16.8mm
Weight: 350g
Length: 85mm (3.355") from front of front bearing to back of pull start.
Width: 31mm ( 1.21") the width neglecting the mounting flanges
36mm (1.43") distance across crankcase measured between the centers
Height: 113mm (4.428")
(contact Ofna for more technical information).
-Fuel with 5%-30% Nitromethane (20% is recommended) and a lubricant
content of 18% or more
-Muffler
-Glow plug (long plug without idle bar)
05-24-02kh
ir/kh
&
FEATURES:
YOU WILL RECEIVE:
SPECIFICATIONS:
REQUIREMENTS:
WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov