Ofna OFN51232
$179.99
in stock? NO
This item is on back-order. It's difficult to know when it will be available to ship..28 Picco W/Pull Start
This is the .28 cu in Picco Engine with Pull Start from Ofna.
This engine is used to power 1/8 scale R/C kits.
FEATURES:
that uses a .21 size engine
ABC construction (Aluminum piston with a chromed Brass cylinder)
Round Rear exhaust
Ball bearing-supported heavy duty 14mm crankshaft
Slide valve two needle carburetor for greater response at the
beginning and end of the power band. This works well for on-road
and racing applications for fast take-offs and high speed.
8mm venturi insert included, giving a good balance between power
and fuel economy
SG (pilot) shaft
Blue anodized aluminum head
9 port sleeve
YOU WILL RECEIVE:
One .28 Ofna Engine w/Slide Valve Carburetor and 8mm venturi One brass collet (to hold flywheel in place)
One silicone rubber insert for Force and Novarossi type manifolds
One running and parts information sheets
One Picco Sticker sheet
SPECIFICATIONS:
Bore: 18.35mm
Stroke: 17.60mm
HP: 2.9
Weight: 11.78oz (330g)
length: 80mm (3.14") front of front bearing to back of pull start
width: 31mm (1.21") width neglecting the mounting flanges
21mm (.83") width between mounting holes same side
36.5mm (1.4") width between mounting holes opposite side
31mm (1.2") crankcase width
height: 109mm (4.3") from bottom of crankcase to top of cylinder head
(contact Ofna for more technical information).
Needle settings: low:10-11 turns out / high: 3-3 turns out
REQUIREMENTS:
content of 18% or more
Muffler or tuned pipe depending on application
Glow plug: OFNG5107
Air Filter: OFNG1137
mcw 4/11/06
ir/jxs
&
WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov