Novak NOV3234

This is the Novak Eiger 2S/3S Brushed Electronic Speed Control and the Rockstar 45 Turn Brushed Motor for Crawling Applications. ESC (NOVM1835); Compatible with all Novak brushed motors including the Terra Claw and Rock Star motors Compatible with 2-3S LiPo cells and 4-9 cell NiMH batteries Heavy duty 2-amp BEC Three throttle modes; Rock Crawl Mode with adjustable drag brake power Standard/Basher Mode for normal FWD/BRK/REV Robotic or Servo Mode for FWD/REV operation only Four adjustable parameters; Brake Power/Throttle Mode (5 settings) Dead Band (5 settings) Drive Frequency (5 settings) Voltage Cut-Off One-Touch programming interface with four multi-colored status LEDs 6V output for cooling fan or other options such as running lights Temperature monito-ring allows user to check ESC operating temperature at any time Thermal overload protection to prevent overheating Water-resistant case with silicone gasket seal One touch setup RoHS compliant Motor (NOVC3547); Designed for crawler vehicles that require precise movement control High number of turns for excellent torque and long run times Rebuildable with easily accessible commutator and replaceable brushes and springs Stand-up brush design High-strength ferrite magnet Dual ball bearings Direct solder wiring tabs for flexible soldering options 120 day limited warranty on both components through Novak Novak Eiger Brushed ESC with Tamiya Type Battery Connector, Gold Plated Bullet Motor Plugs, Mounting Tape, Power Cap, Wires, Heat Sink, Rock Star 45 Turn Brushed Motor and Instruction Manual Pinion gear of modeler's choice Installing in vehicle and connecting to battery and receiver ESC; Motor Compatibility: 380, 540 size brushed Input Cells: 2-3S LiPo or 4-9 NiMH Size: 1.15 x 0.95 x 0.66" (29.0 x 24.3 x 16.8mm) Weight: 0.64oz. (18.1g) without wires On-Resistance: 0.0013 ohms Motor Limit: 20T or higher (2S); 35T or higher (3S) brushed 540 motor, and any 380 size brushed motor BEC: 6V DC/2A Wire Size: 14G Super-Flex Copper-Strand Silicone Wire Motor; Motor Size: 2.07 x 1.42" (52.7 x 36.1mm) Shaft Diameter: 0.125" (3.2mm) accepts all 1/8" pinion gears Bearing: Standard 3/8" x 1/8" Motor Weight: 5.97oz. (169g) jxs 02/23/12 ir/jxs &