Novak NOV3083

This is the Sensor-based Havoc 3S Electronic Speed Control and Ballistic Brushless 8.5 Turn Motor from Novak. Ballistic Brushless 8.5 Turn Motor (NOVC3608); Completely rebuildable allowing upgrades or replacement of various parts Easy to adjust timing assembly Meets ROAR and IFMAR specifications Oversized front bearing 1/2 x 3/16" (12.7 x 4.8mm) for increased load handling and bearing life 12.3mm nickel-plated sintered neodymium rotor for maximum performance in high-temperature conditions 0.125" (3.2mm) pinion shaft accepts all existing pinion gears Sensor-based for excellent torque and low-speed driveability Compatible with the Novak GTB, Slyder and Havoc 3S electronic speed controls Color-coded hand wound stator identifies number of motor winds Heavy duty solder tabs Havoc 3S ESC (NOVM1733); Functions on either two or three cell LiPo batteries in addition to 4-9 NiMH cells Auto-detect brushed motor and battery type modes Compatible with all brushless motors having built-in thermal protection following ROAR guidelines Fully programmable, user-friendly interface with nine adjustable parameters: Minimum Brake (10 settings from 0-27%), Drag Brake (10 settings from 0-27%) Dead Band (5 settings from 2-6%), Minimum Drive (5 settings from 1-5%) Throttle Curve (Linear and Expo), Brake Frequency* (7 settings from 1-8 kHz), Reverse*, Motor Rotation* and LiPo Cut-Off * Available only in brushless mode Smart Braking II enables users to shift from forward to reverse Sensor-based for excellent braking and low-speed driveability 120 day limited warranty through manufacturer on both components Ballistic Spec Brushless 8.5 Turn Motor with Sensor Wire, Havoc 3S ESC with Heat Sink, Cooling Fan, Power Trans Cap Module, Double- Sided Tape and Instructions Installing in vehicle Motor; Watts: 280 kV: 5,000 RPM/volt (unloaded) Maximum RPM: 50,000 Sensor Harness Length: 9" (230mm) Motor Size: 2.07 x 1.41" (52.6 x 35.8mm) (540 size) Motor Weight: 6.6oz (187g) Shaft Diameter: 0.125" (3.2mm) Magnetic Material Operating Temp:* 392°F (200°C) * Motor is not capable of operating at 392°F (200°C). The recommended operating temperature is 160°F (70°C) ESC; Input Voltage: 2-3S Li-Po cells or 4-9 NiMH cells (1.2V/cell) Size: 1.18 x 1.54" (30 x 39.1mm) Weight (without wires): 1.50oz (42.6g) Motor Limit (brushless): 8.5-turn Novak 540-size sensored motor Motor Limit (brushed): 27-turn for 540-size motor/12-turn for 550- size motor On-Resistance (brushless): 0.0012 ohms @ 25°C trans. temp BEC: 6.0 volts DC / 1.5 amps Rated Current: 120 Amps @ 25°C trans. temp Braking Current: 120 Amps @ 25°C trans. temp Status LEDs: 4 Voltage Cut-Off: 6.25V (when LiPo cut-off circuitry is enabled) Power Wires: 14G super-flex copper-strand silicone wire jxs 11/17/10 ir/jxs &