Novak NOV1845
$150.47
in stock? NO
This item is on back-order. It's difficult to know when it will be available to ship.M2 Dig ESC/Dual Terra Claw Brush Motor Combo
This is the Novak M2 Dig 3S Electronic Speed Control
and two Terra Claw 55 Turn Brushed Motors.
M2 Dig 3S ESC;
Independently powers the front or rear motors in a dual-motor
crawler, applicable for dual brushed motor or single brushed
motor applications
Compatible with any Super Crawler dual-system rig, such as EnRoute's
Berg, Team Integy's Super and Unlimited class of crawlers and
Clod Buster based vehicles
Five adjustable parameters; Drag Brake, Dead Band, Minimum Drive,
Drive Frequency and Battery Selection (LiPo LiFe and NiMH)
Can be adjusted and fine tuned via Novak's PC interface, the Novalink
(NOVM5440)-not included
Compatible with dual-brushed motor or single-brushed motor
applications
Universal JST Input Plug fits all popular brand receivers
Water-resistant case with gasket seal
Terra Claw 55 Turn Brushed Motor;
High-strength ferrite magnet
Precise movement control and exceptional torque and long-run times
due to the high turn count
0.125" (3.2mm) shaft diameter fits all common pinion gears
120 day limited warranty on both components through Novak
Novak M2 Dig 3S Electronic Speed Control with receiver plug, power
wires, two Terra Claw 55 Turn Brushed Motors and instruction sheet
Installing in vehicle and connecting to battery and receiver
M2 Dig 3S ESC
Input Voltage: 2-3S LiPo/LiFe cells or 4-9 NiMH cells (1.2V/cell)
On-Resistance (dual motor): 0.0016 ohm at 25° C trans temp
On-Resistance (single motor): 0.0008 ohm at 25° C trans temp
Size: 1.16 x 1.47" (29.5 x 37.3mm)
Weight (w/o wires): 1.30oz (36.9g)
Motor Limit: 27-turn (2S), 33-turn (3S) 540-sized dual brushed motors
BEC: 6.0 volts DC/5.0 amps
Status LEDs: 4 on-board; 2 external
Voltage Cut-Off: 6.25V (2S LiPo), 4.75V (2S LiFe), 9.75V (3S LiPo)
7.125V (3S LiFe) (when LiPoly cut-off circuitry is enabled)
Power Wires: 14G super-flex copper-strand silicone wire
Terra Claw 55 Turn Brushed Motor
Size: 2.07 x 1.42" (52.7 x 36.1mm)
Shaft Diameter: 0.125" (3.2mm)
Motor Weight: 5.97oz (169g)
Input Voltage: 4-7 cells (1.2V/cell) or 2-35 LiPo/LiFe cells
Bearing: Standard, 3/8 x 1/8"
Magnet: High-strength ferrite
Number of Turns: 55
jxs 12/10/10
ir/jxs
&
FEATURES:
YOU WILL RECEIVE:
REQUIREMENTS:
SPECIFICATIONS:
WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov