Kyosho KYOBSW2
$27.81
in stock? NO
This item is on back-order. It's difficult to know when it will be available to ship.Drive bevel - diff gear
This is a Hardened Version of the Larger of the Two Beveled Gears Used in the
Front and Rear Gearboxes of the Kyosho INFERNO, TURBO INFERNO, INFERNO DX,
DX II and USA-1 Nitro Crusher. This Gear is Attached to the Plastic Diff
Case with four 3mmx10mm screws.
FEATURES:
Hardened Material for Extra Strength.
Black Outer Coating to Prevent Corrosion.
Standard Course Kyosho Pitch Teeth.
Direct Bolt-On Fit.
YOU WILL RECEIVE:
One 43 tooth Hardened Beveled Gear.
REQUIREMENTS:
Part is a direct bolt on fit, but modeler must replace the Small
Beveled Gear (KYOC3321), the Diff Housing (KYOC3306)(this is the
inner part of gear) and use a Shim Set (KYOC5573) to adjust mesh.
SPECIFICATIONS:
Part has the same mounting dimensions and specs as the orginal, a
outer diameter of 1.72" a inner diameter of .55" and is .3" thick.
COMMENTS:
The hardened small drive gear is KYOC3321.
The more economical non-hardened version of this gear is KYOC3320.
WLG 10-21-98
ir/jl
WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov