JConcepts JCO8121
$8.50
in stock? NO
This item is on back-order. It's difficult to know when it will be available to ship.RM2 Red O-ring grease and treatment
It's recommended to add a light amount of the Red grease to O-Rings during a fresh build. Lightly spread a fine coat on the outside of a O-rings and plastic washers. Insert the parts in to the shock body gland and assemble as per instructions. Add a tiny bit of Red grease to the treads of the shock-shaft before inserting into the body and in to the gland area. When sliding the shock shaft in to the assembly, move slowly through the O-ring and plastic washer portion allowing the shaft and treads to slightly spread the grease along the inner surfaces. After shock shaft install, wipe the end clean and complete assembly as normal.
For quality, performance and proven results look no further than RM2 products by JConcepts.
High quality grease, smooth consistency
Enough quantity for several builds or re-builds
Clean and simple container for application and storage
For quality, performance and proven results look no further than RM2 products by JConcepts.
FEATURES:
High quality grease, smooth consistency
Enough quantity for several builds or re-builds
Clean and simple container for application and storage
WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov