Hitec/RCD HRC35955S

This is the HiTec HS-5955TG Titanium Gear, Coreless Digital Multipurpose Servo. Programmable digital amplifer with MOSFET drive(programmable features require the HFP-10 programmer Coreless motor, a conventional servo motor has a steel core armature wrapped with with wire that spins inside magnets. In a coreless design, the armature uses a thin wire mesh that forms a cup that spins around the outside of the magnet eliminating the heavy steel core. This design is much lighter resulting in smoother operation and faster response time. Dual ball bearings Titanium-Alloy gear set Ultra hard servo gear shafts with 2 axial brass case bushings Water and dust resistant Universal S connector for use with Futaba, AirtronicsZ, HiTec & JR Metal heatsink,middle case One HS-5955TG servo One 2.75" (45mm) diameter heavy-duty servo horn (wheel) One 2.73" (72mm) long heavy-duty dual sided servo arm One 2.36" (60mm) long heavy-duty dual side servo arm One 1.57" (40mm) long heavy-duty single side servo arm One 1.25" (32mm) long heavy-duty single side servo arm(pre-installed) Four rubber gromets Four brass eyelets Four mounting screws Installing into your model HPF-10 programmer (for programming servo- see comments) Torque: 4.8V 250 oz-in (18 kg-cm) 6V 333 oz-in (24 kg-cm) Speed: 4.8V 0.19 seconds 6V 0.15 seconds Weight: 2.18oz (62 grams) Length: 1.6" (40mm) Width: .8" (20mm) Height: 1.4" (37mm) With the HiTec HFP-10 Programmer the following things can be programmed on this servo: Factory Default Resets Fail Safe on-off Dead Band Width Adjustments End Point Directional Rotation Neutral Point Speed of Rotation Fail Safe Point Preset The following replacement parts are currently available for this servo: Horn set - HRCM5009 kpm01/15/2005 ir/jxs &