Hot Racing SCXT12WG
$154.88
in stock? NO
This item is on back-order. It's difficult to know when it will be available to ship.Billet Aluminum AR44 25:1 Worm Gear Crawler Axle Axial SCX10 II
Hot Racing's billet aluminum AR44 25:1 worm gear axle housing for Axial SCX10 II kit and RTR vehicles provides ultimate strength, a huge gear reduction, and improved ground clearance for unparalleled crawling capabilities.
- 25:1 hardened steel worm gear set for ultimate torque
- Much improved ground clearance
- Locked differential
- Large gear reduction in a compact package
- Self-locking worm gears prevent the vehicle from unintentional rolling; the vehicle will hold itself on steep slopes without the aid of the motor
- Torque twist is minimized due to large gear reduction
- Integrated 4-link mount
- Full ball bearings
- Fits front and rear and requires no vehicle modification for use
- Replaces factory plastic axle case housing, diff cover and gears
- One (1) aluminum differential cover
- One (1) worm gear set
- Three (3) 5x11x4mm ball bearings
- Two (2) 7x14x3.5mm carrier ball bearing
- Weight: 88g as packaged with gears
- Length tube end-to-end: 131.5mm
- Tube center to bottom of pumpkin: 12mm
- Parts from original axle, from the axle shafts out
- Two required per vehicle. If only one is used, a severe mismatch in front/rear gearing will result.
- Medium threadlock (blue threadlocking compound) on screws (screws may not have threadlock from the factory)
- Replaces Axial factory components: axle housing (AX31401), diff cover (AX31384), ring and pinion (AX31405), and locker (AX31404)
description revised by: SN July 24, 2017
FEATURES:
- Black anodized CNC machined billet aluminum axle housing, tubes, differential cover, 4-link mount, and pumpkin- 25:1 hardened steel worm gear set for ultimate torque
- Much improved ground clearance
- Locked differential
- Large gear reduction in a compact package
- Self-locking worm gears prevent the vehicle from unintentional rolling; the vehicle will hold itself on steep slopes without the aid of the motor
- Torque twist is minimized due to large gear reduction
- Integrated 4-link mount
- Full ball bearings
- Fits front and rear and requires no vehicle modification for use
- Replaces factory plastic axle case housing, diff cover and gears
YOU WILL RECEIVE:
- One (1) aluminum axle housing- One (1) aluminum differential cover
- One (1) worm gear set
- Three (3) 5x11x4mm ball bearings
- Two (2) 7x14x3.5mm carrier ball bearing
SPECIFICATIONS:
- Ratio: 25:1- Weight: 88g as packaged with gears
- Length tube end-to-end: 131.5mm
- Tube center to bottom of pumpkin: 12mm
REQUIREMENTS:
- Installation- Parts from original axle, from the axle shafts out
- Two required per vehicle. If only one is used, a severe mismatch in front/rear gearing will result.
- Medium threadlock (blue threadlocking compound) on screws (screws may not have threadlock from the factory)
COMMENTS:
- Compatible with both the Axial SCX10 II kit and RTR- Replaces Axial factory components: axle housing (AX31401), diff cover (AX31384), ring and pinion (AX31405), and locker (AX31404)
description revised by: SN July 24, 2017
WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov