HPI HPI15204
$186.95
in stock? NO
This item is on back-order. It's difficult to know when it will be available to ship.K4.6 High Output Hellfire Engine
This is the HPI K4.6 High Output Pull Start Engine
for the HPI Hellfire, HPIC1050.
Composite body slide valve carburetor
High flow 2-stage foam air filter
Rear exhaust
Two year limited warranty
HPI K4.6 High Output Pull Start Engine with air filter assembly,
cold R5 glow plug (HPIG1504), rubber exhaust gasket and instruction
manual
Fuel: Car blend with 20-25% nitro content
Track Equipment: Glow starter, fuel tubing
Displacement: 0.28 cu in (4.59cc)
Bore: 18.6mm
Stroke: 16.9mm
Practical RPM: 3,100 - 39,500
Maximum Horsepower: 2.95 hp @ 38,000 rpm
Maximum RPM: 41,000
Carburetor Bore: 9.0mm with 8.0mm and 8.5mm reducer
Distance Between Mounting Holes Same Side: 0.83" (21mm)
Distance Between Mounting Holes Opposite Side: 1.5" (38mm)
Height Bottom of Mounting Tabs to Top of Cylinder Head: 3.8" (97mm)
Width at Mounting Tabs: 1.8" (45mm)
Width of Crankcase Below Mounting Tabs: 1.2" (39mm)
Distance from Front Bearing to End of Crankshaft: 1.2" (30mm)
Distance from Pull Start to Front Bearing: 3.4" (83.1mm)
Distance from Center of Engine to Front Bearing: 1.7" (44mm)
Distance from Center of Engine to Pull Start: 1.5" (38mm)
jxs 4/20/06
ir/jxs
&
FEATURES:
YOU WILL RECEIVE:
REQUIREMENTS:
SPECIFICATIONS:
WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov