HPI HPI1300

This is the HPI Nitro Star .12R-XS car engine. ABC construction Clearance "scallops" machined in cylinder head for easier access to engine mounting screws Rear exhaust Front and rear ball bearings Composite carburetor body Slide-valve carburetor Machined aluminum head, purple anodized Black case Aggressive porting Pilot-shaft crankshaft One .12R-XS Nitro Star engine One glow plug w/washer (HPIG1502) One air cleaner w/four foam air cleaner elements and two tie-straps One 1.5mm allen wrench, for adjusting throttle arm position One instruction/part listing sheet One small decal sheet Muffler (exhaust system) depending on vehicle Starting equipment 10-20% nitro fuel Displacement: .12 (2.11cc) Horsepower @ RPM: 1.35hp @ 38,000 RPM Bore: 13.8mm Stroke: 14.0mm Carburetor: Slide type, 5.5mm Ports: 3 Weight: 190g (6.7 oz) Distance between mounting holes same side: 0.43" (11mm) Distance between mounting holes opposite side: 1.24" (31.4mm) Distance/top of cyl.head to bottom of mounting flange: 3.03" (77mm) Height/bottom of crankcase to top of cylinder head: 3.52" (89.4mm) Width between mounting flanges: 1.57" (39.9mm) Width of crankcase beneath mounting flanges: 0.98" (25mm) Throttle arm ball joint diameter: .152" (3.8mm) Air clearer elements are pre-oiled. If a slide-valve linkage is needed, use HPIC2896. NNA 12/09/03 ir/jxs &