HPI HPI10510

This is the 1/10 scale, glow powered, radio controlled, ready-to-run HPI Firestorm 10T Off-Road Stadium Truck. Chassis: Constructed of aluminum, 0.12" (3mm) thick Drive Type: Two wheel (rear) Radio: HPI TF-1 AM 27MHz 2-channel pistol grip, two SF-1 servos sealed removable receiver compartment with room for a five cell receiver battery, transmitter does not have charge jack Engine: HPI G3.0 with pull starter, SG (pilot) shaft with rotary carb dual stage air filter and glow plug Exhaust: Aluminum tuned pipe with header Fuel Tank: 2.5oz (75cc) flip top cap Clutch: Two shoe with 0.8 module 19 tooth clutch bell Transmission: Single speed Ball Bearings: Full set included, 16 total Shocks: Four silicone oil-filled, composite bodied with coil-over spring Main Gear: 0.8 module 50 tooth Gearbox: Sealed, all metal gears Differentials: Planetary geared, sealed and tunable Brakes: Piston actuation, fiber disc Tires: Front-Front Line 2.1" (53mm) wide, 2.2" (57mm) diameter Rear-Ground Assault tapered pin 2.1" (53mm) wide, 2.2" (57mm) diameter Wheels: HPI Scorch 6-spoke 2" (50mm) wide, 2.2" (57mm) diameter with 12mm hex Body: DSX-1 fully painted stadium truck with spoiler, color may vary between samples-see COMMENTS Suspension: Wide track type with captured hinge pins Caster: Adjustable front and rear, caster/toe-in refers to the angle of the front suspension when viewed from the side of the car in relation to the chassis Camber: Adjustable, camber refers to the angle of the tops of the tires from vertical when viewed from front or behind vehicle Steering: Bell crank with servo saver Warranty Period: Two year limited HPI Firestorm 10T Stadium Truck, 2-ch radio, engine, glow plug, air filter, tuned pipe, header, painted body, decals, tires, foam inserts, wheels 19 tooth clutch bell, 50 tooth spur gear, instructions AA Batteries: 12, 8 for transmitter, 4 for battery box Glow Starter Misc. Items: Building and track equipment Fuel: 2-cycle glow fuel with 20%-25% nitromethane, 16% lubricant- Most of the fuels we carry meet or exceed the lubricant content required for optimum performance and maximum engine life. In the past, the conventional lubricant content used in fuel was 18%. But with new advanced technologies, fuels like Red Alert and O'Donnell for example, have a better quality of lubricants even though the percentages of lubricant content are lower. These high-tech lubricants provide exceptional cooling and protection. Vehicle- Length: 16.7" (425mm) Front Width: 12.8" (325mm) Rear Width: 12.9" (327mm) Height: 6.6" (167mm) measured at rear wing Weight: 4.5 lbs (2055g) approx. Wheelbase: 11" (279mm) adjustable Front Tread: 10.8" (274mm) Rear Tread: 11" (279mm) wheels on-center side-to-side Front Track: 12.75" (324mm) Rear Track: 12.9" (329mm) outer edges of wheels Ground Clearance: 1.4" (35mm) Gear Ratio: 4.11:1 Body- Length: 16.4" (416mm) Width: 6.6" (168mm) at rear wheels (widest point) 5.7" (144mm) ahead of front wheels (thinnest point) Height: 3.8" (97mm) For Replacement Ball Bearings use: Qty. Size Location Qty. Bearing Set 4 5x10mm Front Wheels 2 DTXC1535 4 5x10mm Rear Wheels 2 DTXC1535 2 5x10mm Top Shaft 1 DTXC1535 2 5x10mm Idler Shaft 1 DTXC1535 2 10x15mm Differential 1 DTXC1595 2 5x10mm Clutch 1 DTXC1535 Body pictured on the box is painted orange and black with all decals applied. It is not possible to request a specific color scheme or design. The bodies are painted by the manufacturer and may vary between samples. jxs 12/04/06 ir/jxs &