HPI HPI10410

This is the 1/10 scale glow powered, radio controlled, ready-to-run HPI Nitro RS4 MT2 G3.0 Off-Road Truck. Chassis: 0.098" (2.5mm) thick 6065 anodized aluminum, gray in color Drive: Four wheel drive Drive Type: Shaft driven Engine: HPI G3.0 .18 cu in (3.0cc) with shaft start, rotary carburetor and glow plug Exhaust: Aluminum header and tuned pipe, black in color Electric Starter: HPI Roto Start with steel shaft Radio: HPI TF-1 pistol grip 27MHz AM with steering and throttle trim dual rate and servo reverse, two SF-1 standard servos, transmitter does not have charge jack Fuel Tank: 3.4oz (100cc) flip top cap Clutch: 2-shoe Transmission: Single-speed Ball Bearings: Fully equipped, 18 total Shocks: 4 oil-filled, composite bodied with coil-over spring Main Gear: 52 tooth plastic Gearbox: Sealed front and rear Differentials: Planetary geared Brakes: Single, fiber disk Tires: Yokohama Geolander 4.05" (103mm) outer diameter, 1.98" (50mm) wide with inner foams Wheels: Chrome finish, split 5-spoke 2.2 (56mm) diameter, 2.0" (51mm) wide Body: Pre-painted pickup stadium truck style Bumpers: Front, plastic Suspension: Front and rear double wishbone Camber Tie Rods: Non-adjustable Steering Tie Rods: Non-adjustable Steering: Bell-crank with servo saver One HPI Nitro RS4 MT 2 G3.0 with oil-filled shocks, .18 cu in (3.0cc) engine, tires, foam inserts, wheels, Roto Start electric starter 15 tooth clutch bell, 52 tooth spur gear, instructions, pre-painted body with rear wing, 2-channel radio, glow plug, decals and instruction sheet Radio Batteries: 12 AA size 6 cell 7.2V flat battery pack and charger for Roto Start Glow Starter: 1.2 volt Misc. Items: Fuel bottle, building and track equipment Fuel: 2-cycle glow fuel with 10%-15% nitromethane, 16% lubricant- Most of the fuels we carry meet or exceed the lubricant content required for optimum performance and maximum engine life. In the past, the conventional lubricant content used in fuel was 18%. But with new advanced technologies, fuels like Red Alert and O'Donnell for example, have a better quality of lubricants even though the percentages of lubricant content are lower. These high-tech lubricants provide exceptional cooling and protection. Vehicle- Length: 17.4" (443mm) Width: 12.5" (317mm) Height: 6.5" (165mm) Weight: 4.96lbs (2250g) approx. Wheelbase: 11.75" (298mm) wheels on-center front-to-rear Tread-Front: 10.25" (260mm) Rear: 10.75" (273mm) wheels on-center side-to-side Front Track: 12.5" (317mm) Rear Track: 12.5" (317mm) wheels at outer edges Ground Clearance: 1.5" (38mm) Tires- 2.2" (56mm) ID x 4.05" (103mm) OD 1.98" (50mm) W Body- Length: 15.5" (394mm) Width: 6.4" (163mm) at rear wheels (widest point) 6.3" (161mm) behind from wheels (thinnest point) Height: 4.4" (111mm) For Replacement Ball Bearings use: Qty. Size Location Bearing Set Qty. (4) 5 x 11mm front & rear gearboxes (use 2-DTXC1547) (4) 10 x 15mm front & rear diffs (use 2-DTXC1595) (2) 5 x 11mm front hubs (use 1-DTXC1547) (2) 10 x 15mm front hubs (use 1-DTXC1595) (4) 5 x 11mm rear hubs (use 1-DTXC1547) It is not possible to request a specific radio channel or body color because they are supplied by the manufacturer at random. For an optional engine from O.S. Max, the .18CV-RX (OSMG2104) and the Complete One-Piece Pipe (OSMG2988) can be used. jxs 07/19/07 ir/jxs &