Hobbico HCAA2012

This is a Ready-To-Fly, Radio Controlled, Electric Powered, Hand Launch Speed Pilot Airplane Set with Auto Cut-Off, Battery, Motor and 2 Ch Radio. Recommended for ages 12 and up. This airplane will perform basic aerobatics, but not rolls. Fully assembled and ready for flight in only a few quick steps Includes everything needed to assemble and fly the airplane including the radio system. The Hobbico two channel, two stick radio system operates the rudder and elevator. Radio has servo reversing, LED battery power status indicator, charging jack and a comfortable-hold transmitter case. The auto cut-off feature shuts off the motor when battery power is low, allowing modeler to use remaining power to control the plane. On the fuselage is a radio ON/OFF switch for turning on the radio system and setting the control throws. Located near the ON/OFF switch is a small motor-start button. This button is pressed to start the motor when the model is ready to fly, preventing unintentional full-power starts. Flight battery is a rechargeable NiMH (Nickel-Metal Hydride) pack that allows for longer flight times. Airplane looks similar to a Cessna plane and is constructed of foam Fuselage is yellow; the wing and tail assemblies are Purple. The fuselage has Purple and Blue stipes. The wing and tail assemblies have Blue and Yellow stripes. Warranty: Hobbico guarantees this kit free from defects in both material and workmanship at the date of purchase. One Speed Pilot Ready-To-Fly Electric Airplane with pre-installed Hobbico 2-Channel 2-Stick Radio, Motor, Auto Cut-Off. One Rechargeable NiMH Battery Pack with Hobbico Custom Connector Two Propellers One Tail Set (Vertical and Horizontal Stabilizers) One 12V DC Field Charger (HCAP0113) One Tool Set (screwdriver, open-end wrench and allen wrench) One Instruction Manual One Hardware Package One how-to instructional video (8) AA size alkaline batteries for the transmitter Charging the included Nickel-Metal Hydride battery with DC charger Final assemblies of attaching wing, tail sections, propeller, struts, landing gear and installing the battery pack. Checking trims on the control surfaces Wingspan: 37.5" (953mm) Wing Area: 213 sq in (13.7 sq dm) Flying Weight: 1.4lb (635g) Wing Loading: 14.9 oz/sq ft (45g/sq dm) Length: 29.5" (750mm) Center of Gravity: between 1-7/8" and 2¼" back from the leading edge of the wing. Elevator Adjustments: 3/8" (9.5mm) up and down Rudder Adjustments: ½" (12.7mm) right and left Motor: 380 size On-Board Battery: 8.4V 1300mAh AA size batteries with Hobbico Custom Connector Radio Frequency: 27MHz (random channels) Do Not charge the included Nickel Metal Hydride battery with any charger that is not specifically designed for charging Nickel Metal Hydrides. Overheating and shortened battery life could occur. Airplane is designed for outdoor use only. If fuselage gets cracked or damaged, apply white glue and cellophane tape, then let it dry overnight. Final assemblies include: The entire tail assembly goes together by just installing three screws. Wing mounts with two screws. Struts simply hook into the wing and screw into the bottom of the fuselage. Mount one of the included propellers and attach the landing gear. For Transmitter NiCd Conversion Kit, use DTXP4009. Flight times with a fully charged battery will run about 10 minutes. If the airplane takes off from a runway, flight time will be significantly reduced. For AC wall charger use HCAP0119 JAL 1/15/01 ir/jl &