Hot Racing CB20EL08
$43.88
in stock? NO
This item is on back-order. It's difficult to know when it will be available to ship.Wide Axle Kit - Tamiya Clod Buster
Hot Racing aluminum wide axle kit for the Tamiya Clod Buster vehicles (Clod, Super Clod, or Bullhead)
- Bushing support kingpins for super smooth steering action
- Smaller c-hub make it for possible 2.2 in wheel
- CNC 6061-T6 Aluminum construction, silver in color
- These tubes will increase the drive shaft strength of your Clod rock crawler
- This kit requires a linked suspension and is NOT compatible with the factory radius arm (ladder bar) suspension
- Two (2) hardened steel drive shafts
- Two (2) aluminum bevel joint side gear couplers
- Four (4) brass bushings
- Four (4) 5x8mm nylon steering bushings
- Two (2) aluminum link mounts
- Four (4) 4x12mmscrews
- One order completes one axle. Order sets to complete one model.
- This kit requires a linked suspension and is NOT compatible with the factory radius arm (ladder bar) suspension
- Gearbox flange diameter: 29.5mm (1.16 inch)
- 5x8mm bearing can be use in place of the bushing
- Replacement/spare drive axle shafts are Hot Racing SCB20EL
- Replacement/spare hardware kit is Hot Racing RCB20EL08
description revised by: SN April 15, 2015
FEATURES:
- 15mm widen track on each side (total 30mm)- Bushing support kingpins for super smooth steering action
- Smaller c-hub make it for possible 2.2 in wheel
- CNC 6061-T6 Aluminum construction, silver in color
- These tubes will increase the drive shaft strength of your Clod rock crawler
- This kit requires a linked suspension and is NOT compatible with the factory radius arm (ladder bar) suspension
YOU WILL RECEIVE:
- Two (2) aluminum extended axle tubes- Two (2) hardened steel drive shafts
- Two (2) aluminum bevel joint side gear couplers
- Four (4) brass bushings
- Four (4) 5x8mm nylon steering bushings
- Two (2) aluminum link mounts
- Four (4) 4x12mmscrews
REQUIREMENTS:
- These tubes will ONLY work with the Hot-Racing CB2108 Clod Buster steering knuckles!- One order completes one axle. Order sets to complete one model.
- This kit requires a linked suspension and is NOT compatible with the factory radius arm (ladder bar) suspension
SPECIFICATIONS:
- Approximate total length: 93mm (3.7 inch)- Gearbox flange diameter: 29.5mm (1.16 inch)
COMMENTS:
- Replaces Tamiya E1 axle tubes, BS4 drive shaft, and BS5 drive shaft- 5x8mm bearing can be use in place of the bushing
- Replacement/spare drive axle shafts are Hot Racing SCB20EL
- Replacement/spare hardware kit is Hot Racing RCB20EL08
description revised by: SN April 15, 2015
WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov