Associated ASC80904

This is the electric powered, radio controlled 1/8 scale Factory Team RC8Be Buggy Kit from Associated. Chassis: Hard anodized 7075 T-6 aluminum, 0.12" (3mm) thick with molded composite front and rear braces Drive: Four wheel shaft with 3.5mm light CVA drivetrain and blue aluminum drive hexes, rear molded CVA boots keeps dirt out of rear joints Shocks: Factory Team 16mm Big Bore with 4mm diameter TiN coated stainless steel shafts, 25W silicone shock oil Shock Towers: 0.20" (5mm) thick aluminum Battery Tray: Molded plastic, supports two ROAR-approved 1/10 scale 7.4v LiPo battery packs with room for foam pads, three hook and loop battery straps Motor Mount: Rigid one-piece Body: Clear lexan with cooling scoops and predrilled wing with adjustable angle and location Tires: Pro-Line M3 Holeshots with molded inserts Wheels: White plastic Factory Team, 3.27" (83mm) diameter, 1.83" (46.5mm) wide, blue aluminum nylock wheel nuts Suspension: Adjustable pivot bushings for different pivot height options, 3/8" (10mm) thick suspension arms, 7075 blue aluminum mounts Caster: Adjustable, blocks adjust 14, 16 or 18° with molded inserts, caster/toe-in refers to the angle of the front suspension when viewed from the side of the car in relation to the chassis Camber: Adjustable, camber refers to the angle of the tops of the tires from vertical when viewed from front or behind vehicle Steering: Dual bellcrank with optimized geometry for greater consistency and reduced bump steer Pinion Gear: 15 tooth Spur Gear: 46 tooth composite Factory Team RC8Be Buggy Kit with wheels, pinion and spur gear, clear body, shocks, wing, decals and instruction manual Radio: 2-channel with heavy duty steering servo ESC: 1/8 scale Specific Motor: 1/8 scale Specific Battery: 1 or 2 6-cell NiMH packs (7.4V) OR 1 or 2 2-cell LiPo packs (7.4, 11.1, or 14.4V) Charger: Depending on battery type Building and track equipment Vehicle- Length: 18.5" (470mm) Width: 12" (305mm) Weight: 7.8 lbs (3570g), actual weight will vary depending on electronics Wheelbase: 12.7" (323mm) Track: 10.2" (259mm) distance between outer edges of tires Internal Gear Ratio: 4.30:1 Body- Length: 12.8" (325mm) Width: 7.9" (200mm) Height: 3.9" (100mm) For Replacement Ball Bearings use: Qty. Size Location Qty. Bearing Set 6 8x16x5mm Diffs/ Front & Rear Ends 3 ASCC9716 2 5x10x4mm Clutchbell 1 ASCC9717 2 6x10mm Bellcrank 1 ASCC2604 2 15x21x4mm Rear End 1 ASCC6862 4 10x6x3mm Steering 1 ASCC6861 4 8x5x3mm Steering 1 ASCC6861 jxs 5/04/10 ir/jxs &