Associated ASC4019C

This is the electric powered, radio controlled, Associated Factory Team 12R5.1 1/12 scale On-Road Pan Car Kit. Includes the #4690 (ASCC4690) LiPo Conversion Kit that consists of; #4691 LiPo Chassis #4695 Top Plate #4692 Lower Pod Plate #4696 Two Shock Mount Uprights #4693 Upper Pod Plate #4698 Hinge Pin Brace #4694 Chassis Brace #4699 Five Aluminum Standoffs Chassis: 0.10" (2.5mm) thick woven carbon fiber with top plate, wide rear pod for easy installation of brushless motors and better heat dissipation, Factory Team pivot ball-link chassis allows for independent roll, bump and alignment adjustment, now optimized for use with 1S LiPo batteries for smoother mid-corner steering in high traction conditions Drive: Two wheel rear Ball Bearings: Full set included Differential: Ball type Motor Mount: Factory Team blue machined aluminum Shock: Factory Team shock with through-shaft design for equalized damping throughout the full stroke with no unwanted rebound, shock also controls chassis droop and adjusts with a turnbuckle wrench, woven carbon fiber center shock tower with four mounting positions Suspension: Pivot ball link rear suspension allowing independent adjustments for chassis roll, bump and alignment, active strut front end with symmetric components and adjustable caster and track width Bumper: Foam front Caster: Adjustable, caster/toe-in refers to the angle of the front suspension when viewed from the side of the car in relation to the chassis Camber: Adjustable, camber refers to the angle of the tops of the tires from vertical when viewed from front or behind vehicle Ackerman: Adjustable with spacers, Ackerman describes the effect of the inside front wheel turning faster than the outside front wheel during turns Associated Factory Team 12R5.1 Pan Car Kit with LiPo Conversion Kit Decals, 96T spur gear illustrated instruction manual Radio: 2-channel with mini steering servo Electronic Speed Control: For stock or modified motor Motor: 540 size Battery: 4-cell sub-C 2x2 flat configuration NiMH, or 1S LiPo pack Battery Charger: For selected battery Wheels and Tires: 1/12 scale on-road Pinion Gear: 61 pitch, number of teeth dependent on selected motor Body: 1/12 scale high downforce type Building and track equipment Length: 10.4" (265mm) Width: 6.7" (170mm) Wheelbase: 7.7" (196mm) Weight: 29.3oz (830g) Internal Gear Ratio: 1:1 For Replacement Ball Bearings use: Qty. Size Location Qty Bearing Set 2 1/4x3x8" Rear Axle 2 ASCC7600 2 1/4x3x8" Ride Height Adjuster 2 ASCC7600 8 1/8x5/16" Fr & Rear Wheels 4 ASCC4125 jxs 02/21/12 ir/jxs &