Castle Creations CSE011-0106-00
$9.95
in stock? YES
Receiver Harness: Mamba Monster X 011-0106-00
Mamba Monster X Receiver Harness Connection Instructions
To Remove the Receiver Harness:
Place slight pressure with thumb on capacitor shroud (Figure 1).
Grip the harness close to the 8 pin connector and pull gently, at a slight angle away from ESC, to remove the harness from the ESC pin header (Figure 2).
To Replace the Receiver Harness:
Place slight pressure with thumb on capacitor shroud (Figure 1).
Following the color coded wiring diagram provided on the Monster X label, place the 8 pin connector onto the ESC pin header (Figure 3).
Gently press on the 8 pin connector to fully engage with the ESC pin header.
Reconnect cooling fan and receiver connections.
To Remove the Receiver Harness:
Place slight pressure with thumb on capacitor shroud (Figure 1).
Grip the harness close to the 8 pin connector and pull gently, at a slight angle away from ESC, to remove the harness from the ESC pin header (Figure 2).
NOTE:
Do not yank or forcefully pull harness out of ESC. May cause damage to ESC or harness. To Replace the Receiver Harness:
Place slight pressure with thumb on capacitor shroud (Figure 1).
Following the color coded wiring diagram provided on the Monster X label, place the 8 pin connector onto the ESC pin header (Figure 3).
NOTE:
Misalignment of the harness will prevent the ESC from operating. Be sure that the brown wire is plugged in next to the negative (-) black power wire. Gently press on the 8 pin connector to fully engage with the ESC pin header.
Reconnect cooling fan and receiver connections.
WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov