Hitec/RCD HRC31815S
$49.99
in stock? NO
This item is on back-order. It's difficult to know when it will be available to ship.Mega Sail Arm Servo HS-815BB: Universal
This is in extremely powerful sail winch servo, with dual ball bearings and
Hitec S type connector.
Connector is compatible with all modern receivers and wiring accessories
Indirect drive motor
Water tight case
Transit time .46 seconds/140°
Torque 231 oz-in
Servo mounting screws, grommets, and eyelets
1 each of the following servo arms. Large wheel, large X, and large
straight arm.
1 sail arm, 122mm overall length, 110mm center of mount to outside
hole.
Special Y- harness for use with BEC receivers (see comments)
This servo consumes 800mAh UNLOADED, Hitec states that it REQUIRES
a minimum of 1200mA receiver battery, 6V (5 cell) is STRONGLY
recommended.
If connecting to a BEC receiver, the Rx battery must be plugged in
to one side of the supplied Y harness, the servo into the other
side, and then connected to the receiver. IT WILL NOT WORK IF RUN
WITH A BEC RX CONNECTED IN ANY OTHER WAY!!!!!
Standard Rx's connect as normal
For replacement Gear Set, order HRCM6350.
9-3-97 *8) JBR
UPDATE JMM 2/8/03
SPECIFICATIONS:
DIMENSIONS:
66x30x56.7mm, 2.59x1.18x2.23" (L,W,H)
YOU WILL RECEIVE:
COMMENTS:
WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov