Novak NOV3016
$149.99
in stock? NO
This item is on back-order. It's difficult to know when it will be available to ship.Goat 2s Crawler brushless System 21.5t
This is the Goat Crawler Brushless/Brush Electronic Speed Control
and the 21.5 Turn Crawler Brushless Motor Crawler System from Novak.
Crawler ESC-
Two specific crawling driver profiles that feature zero reverse delay
and high-powered drag brakes (or "hill or "hold" brakes)
Built-in LiPo cut-off protection prevents batteries from going below
the critical safety voltage level
User replaceable input harness
Heavy duty 6V/5A BEC
Radio priority and polar drive circuitry
High-efficiency heat sink
Power output for optional 6V fan (available separately, NOVC5648)
Water resistant case
Thermal overload protection
#3420 21.5 Turn Crawler Motor-
Sensor-based for excellent low-speed driveability
High-strength sintered rotor
Oversized front bearing for extra durability and extended life
Ribbed aluminum end bells reduce weight and provide additional
cooling
Direct solder wiring tabs for flexible soldering options
120 day warranty on both products through Novak
Novak Goat Crawler Electronic Speed Control with instructions
Tamiya style JST battery connector, use-replaceable input harness
double-sided tape and #3420 21.5 turn Crawler brushless motor
Installing in vehicle and connecting to receiver and battery
ESC-
Foward/Reverse: Forward, Drag Brake, Reverse
Input Voltage: 4-7 NiCd/NiMH cells (1.2V per cell) or 2 LiPo cells
On-Resistance: 0.0012 ohms (brushless per phase)
0.0012 ohms (brushed)
Size: 1.54" x 1.18" (39 x 30mm)
Weight: 1.49oz (42.2g) w/o wires
Rated & Braking Current: 120 amps (brushless per phase);
120 amps (brushed)
Power Wires:14-Gauge
BEC: 6.0V/5.0A
Motor Limit: 18.5-turn (brushless);
27-turn stock motor (brushed mode)
Discrete Steps: 512 Forward; 512 Reverse
Battery/Motor plug: Tamiya (battery); None (motor)
Voltage Cut-off: 6.25V (when LiPoly cutoff circuitry is enabled)
Motor-
Watts: 85
kV (unloaded): 1,800 RPM/Volt
Motor Size (length/diameter): 2.08 x 1.41" (52.8 x 35.8mm)
Shaft Diameter: 0.125" (3.2mm), accepts all existing pinion gears
Motor Weight: 6.61 oz (187 g)
Front Bearing: Oversized, 1/2 x 3/16"
Rear Bearing: Standard, 3/8 x 1/8"
jxs 02/14/11
ir/jxs
&
FEATURES:
YOU WILL RECEIVE:
REQUIREMENTS:
SPECIFICATIONS:
WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov