HPI HPI107824

HPI Racing brand HPI Nitro Star G3.0 High Output Engine with Pull Starter.
FEATURES:
Finned black coated crankcase for added strength and to help cool the
engine
Composite body slide valve carburetor with 7mm bore
Side exhaust
SG crankshaft
Two year limited warranty beginning at date of purchase
YOU WILL RECEIVE:
G3.0 High Output Engine with Pull Starter, Carburetor, R5 Cold Glow
Plug, Foam Air Filter, three Zip Ties and Instructions
REQUIREMENTS:
Fuel: Car blend with 20-25% nitro content
Track Equipment: Glow starter, fuel tubing, glow plug wrench
SPECIFICATIONS:
Displacement: .18 cu in (2.95cc)
Bore: 16.8mm
Stroke: 13.6mm
RPM: 30,000
Practical RPM: 6,500 - 32,000
Power: 2.2 ps/kw
Carburetor Settings:
High Speed Needle, 1-2/2 turns clockwise from flush
Idle Screw: Set throttle trim on transmitter so that throttle is in
neutral position, turn screw counter-clockwise to reduce idle
speed, or clockwise to increase idle speed. Set idle speed high
enough to keep engine running smoothly, but not high enough to
engage the clutch.
Low Speed Needle: No adjustment recommended. For increased
performance, set after high-speed needle is adjusted. Turn needle
in 1/8 turn increments for better bottom end throttle response.
Caution-never turn in more than 2 turns from flush. This will
cause engine to run too lean and will result in damage
Distance Between Mounting Holes Same Side: 0.83 (21mm)
Distance Between Mounting Holes Opposite Side: 1.2 (30mm)
Height Bottom of Mounting Tabs to Top of Cylinder Head: 3.0 (76.9mm)
Width at Mounting Tabs: 1.6 (40mm)
Width of Crankcase Below Mounting Tabs: 0.99 (25.1mm)
Distance from Front Bearing to End of Crankshaft: 1.1 (29mm)
Distance from Pull Start to Front Bearing: 2.9 (75.3mm)
Distance from Pull Start to End of Crankshaft: 4.2 (107mm)
Distance from Center of Engine to Front Bearing: 1.5 (37.2mm)
Distance from Center of Engine to Pull Start: 1.5 (39mm)
jxs 03/25/15
ir/jxs