RC Lights RCL106A
6 Led Add-On for Rpm Roof Canisters 3mm 14
Product Features
*Brightest LEDs Industry Wide
*Simple & Easy Installation
*All Mounting Hardware Included
*Fast Body Removal
*LED Add-On (LED Controller Req. ) Overview This is your no-solder LED lighting solution for RPM Light Canisters & RPM Tail Lights! Use RCL106A to add 6 3mm white LED lights to RPM Roof Canisters to any controller with 6 extra constant LED channels (see RCL104). Add-On for RCL104 to make a 10 LED System. Compatible with RPM Roof-Mounted Light Bar Set RPM80922, RPM80923 & RPM80925
Direct fit for Slash 4x4, Slash & SC10. To change LED sizes or colors use 5mm or 3mm LEDs. This system add-on requires a LED controller and power source. Add-On for RCL104. If not used with RCL104 use with Standard 10 LED Controller RCL5051 or any other LED controller with available channels. TOTAL LED CURRENT DRAW (@6V): 110mA (A standard servo draws approx. 350mA) Blue, Green, White, White Strobe, Red Strobe LEDs FORWARD VOLTAGE: 3.2V MAX CURRENT: 30mA Amber, Red LEDs FORWARD VOLTAGE: 1.9V MAX CURRENT: 30mA DIY HOBBYISTS: If connecting LEDs directly to power a current limiting resistor must be installed on each LED or it will blow and void the warranty. (160 ohm @ 6V)
*Lights are designed to be used in extreme nighttime and low visibility running environments and are very high output.
*DO NOT look directly into beam.
*Brightest LEDs Industry Wide
*Simple & Easy Installation
*All Mounting Hardware Included
*Fast Body Removal
*LED Add-On (LED Controller Req. ) Overview This is your no-solder LED lighting solution for RPM Light Canisters & RPM Tail Lights! Use RCL106A to add 6 3mm white LED lights to RPM Roof Canisters to any controller with 6 extra constant LED channels (see RCL104). Add-On for RCL104 to make a 10 LED System. Compatible with RPM Roof-Mounted Light Bar Set RPM80922, RPM80923 & RPM80925
Direct fit for Slash 4x4, Slash & SC10. To change LED sizes or colors use 5mm or 3mm LEDs. This system add-on requires a LED controller and power source. Add-On for RCL104. If not used with RCL104 use with Standard 10 LED Controller RCL5051 or any other LED controller with available channels.
YOU WILL RECEIVE:
Instruction Set - (6) 14" wire extensions RCL539014 (6) 3mm white LEDs RCL5280W (6) 2P connector housings (2) zip ties RCL5080 SPECIFICATIONS:
*Lights are designed to be used in extreme nighttime and low visibility running environments and are very high output.
*DO NOT look directly into beam.
WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov