Hot Racing CB1020
Drive Shaft Tube W/ Bearing C-Hubs Clod Buster
Hot Racing aluminum axle tube kit (standard width) for the Tamiya Clod Buster vehicles (Clod, Super Clod, or Bullhead)
- No steering limit stop
- Compatible with stock or Hot Racing CB2108 steering knuckles
- Compatible with stock radius arm (ladder bar) suspension
- CNC 6061-T6 Aluminum construction, silver in color
- These tubes will increase the drive shaft strength of your Clod Buster axle
- Four (4) 5x8mm bearings
- One order completes one axle. Order sets to complete one model.
- Approximate width: 63.8mm) at the gearbox (54mm) at the upright
description revised by: SN April 15, 2015
FEATURES:
- Bearings support kingpins for super smooth steering action- No steering limit stop
- Compatible with stock or Hot Racing CB2108 steering knuckles
- Compatible with stock radius arm (ladder bar) suspension
- CNC 6061-T6 Aluminum construction, silver in color
- These tubes will increase the drive shaft strength of your Clod Buster axle
YOU WILL RECEIVE:
- Two (2) aluminum axle tubes- Four (4) 5x8mm bearings
REQUIREMENTS:
- Do not install the inner BD5- One order completes one axle. Order sets to complete one model.
SPECIFICATIONS:
- Approximate length: (78mm) - Approximate width: 63.8mm) at the gearbox (54mm) at the upright
COMMENTS:
- Replaces Tamiya E1 axle tubesdescription revised by: SN April 15, 2015
WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov