Hot Racing ATF9337
Steel Helical Diff Ring/Pinion - BLX 3S 4S
Hot Racing steel helical spiral 37T/13T gear set for Arrma 1/10 4WD
The 37T/13T gear set is the stock gear ratio.
- High carbon steel construction
- Stronger than the stock bevel Plastic gears
- Maintains the stock 37T/13T ratio
- One (1) 13 tooth spiral cut pinion gear
- Installation following kit manual
- Medium threadlock (blue threadlocking compound) if screws are threaded into metal
- Hot Racing SPL10G05 high temp grease recommended for the diff gear.
- Use Silicone Diff Fluid for Gear Diffs inside.
- ARAC4023 you will only use the differ cover plate do not need to use the back plate.
- Requires removal of slipper nut if installed. Remove Slipper Nut. Set desired slipper tension. Remove transmission. Apply a few drops of blue threadlocker down the rear slipper hub opening onto the slipper tension screw. Allow 24hrs to cure. Reinstall transmission.
The 37T/13T gear set is the stock gear ratio.
FEATURES:
- Precision machined helical spiral cut gears offer inherently greater strength and smooth operation than the factory bevel gears. (it has been updated to 15g lighter)- High carbon steel construction
- Stronger than the stock bevel Plastic gears
- Maintains the stock 37T/13T ratio
YOU WILL RECEIVE:
- One (1) 37 tooth diff spiral cut ring gear- One (1) 13 tooth spiral cut pinion gear
REQUIREMENTS:
- ARAC4023 Composite Diff case Cover Or ATF11A01 Aluminum Diff case Cover. - Installation following kit manual
- Medium threadlock (blue threadlocking compound) if screws are threaded into metal
- Hot Racing SPL10G05 high temp grease recommended for the diff gear.
- Use Silicone Diff Fluid for Gear Diffs inside.
SPECIFICATIONS:
- Weight: 2.35oz (66.75g)COMMENTS:
- Replaces bevel-Plastic gears AR310873. AR310872.- ARAC4023 you will only use the differ cover plate do not need to use the back plate.
- Requires removal of slipper nut if installed. Remove Slipper Nut. Set desired slipper tension. Remove transmission. Apply a few drops of blue threadlocker down the rear slipper hub opening onto the slipper tension screw. Allow 24hrs to cure. Reinstall transmission.
WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov