Hot Racing aluminum transmission gearbox case with aluminum motor plate and arm mounts for use in the TRA Bandit, Rustler, 2WD Stampede, and 2WD Slash
- CNC machined 6061 billet aluminum transmission case
- CNC machined 6061 aluminum motor plate with added motor heat sink
- CNC machined 6061 aluminum arm mount
- Longer motor mounting slot to accommodate a greater gear ratio range
- Motor plate with mounting for slash stock rear bumper
- Reuses stock gears and transmission internals (see requirements below)
- One (1) aluminum transmission case with aluminum heat sink motor plate
- Left and right aluminum arm mounts
- Installation hardware
- Assembly and installation
- Reuse of internal gear and components from existing transmission
- Slipper assembly and spur gear
- Medium threadlock on screws
- Spur gear dust cover, including the plastic TRA 3792 or the Hot Racing aluminum TR3201
- For vehicles without a rear bumper, installation may not use all included hardware
- This is an empty gear case and does not include any gears, shafts, or bearings, slipper, spur gear, etc.
- Any transmission peripherals shown in photos (slipper, spur gear, bearings, etc. ) are not included
- See Hot Racing TE12GX01 for a composite version of this case
description revised by: SN October 25, 2017